
No. 1
Heat pump repair
Olympia winters stay wet and just above freezing for weeks, so defrost does a lot of work. We read the coil sensor, the defrost board and the charge before anything else.
Go to the service page
Pricing, start to finish
Amounts are left off this site on purpose, because the right number depends on the furnace, heat pump or dryer in front of the technician. What we can lay out is how the money side of a visit runs, from your first call to the invoice in your hand.
Quick answer
Every repair visit begins with a diagnostic fee, and you learn its amount from the office while the appointment is being arranged. After testing, the technician hands you a written repair price and waits for your decision. Say yes, and the fee melts into that repair total. Say no, and you owe the fee and nothing more. New heating and cooling systems are quoted in writing, with equipment and installation combined in one figure.
The fee pays for the trip and for the testing that turns a symptom into a named cause. Its amount comes from the office during scheduling, so it is settled long before anyone rings your doorbell. On site, the technician measures instead of guessing: microfarads on a run capacitor, flame-sensor microamps on a gas furnace, superheat and subcooling on a heat pump, continuity through a dryer's thermal fuse, amp draw on a dishwasher drain pump, or resistance across an oven's bake element.
Where the fee lands depends on your answer. Approve the work, and that fee gets tucked into the repair figure, not perched above it as an extra line. Pass on the work, and the fee covers the visit in full, with nothing added, while the written findings stay with you for later.
Before the repair itself begins. Once the fault is pinned down, you get the price in writing, and the technician waits for your go-ahead before swapping, recharging or adjusting anything. When two reasonable fixes exist, say a worn igniter by itself versus the igniter plus a flame sensor reading low, both can be written side by side so you pick.
The truck is stocked for the usual suspects: run capacitors, contactors, hot-surface igniters, flame sensors, fan motors, belts, valves, drain pumps, door switches and dryer thermal fuses. Some parts are model-specific, like the control board in a particular furnace or a front-loader's door boot; for those, the cost is listed on the estimate ahead of any order. The office then calls to arrange the return trip once the part arrives.
As one number. A new heat pump, furnace, central air conditioner, air handler or mini-split comes with a written quote that merges the equipment and the installation into a single total, along with a plain description of the job: placing the outdoor unit, tying the ductwork into the new equipment, running and charging the line set, and wiring the thermostat.
That number is written for your particular house after a technician has seen it. A 1940s one-story home in Beachcrest with no ductwork, a Hawks Prairie heat pump swapped onto the same pad, and an ADU on Rochester acreage each call for different work. When a job needs something outside our license scope, such as a new power feed, the quote names it so you can line that up separately.
Your warranty terms appear on the invoice and are tied to the parts we replaced or the system we installed. Keep that paper somewhere safe. Should the same trouble return, call the office, mention the earlier visit, and the follow-up is handled according to those written terms.
You pay against that invoice for the work you approved, with the diagnostic fee already sitting inside the repair figure. Ask the office about accepted payment methods while booking, and the doorstep stays simple. Explanations in Spanish are available on request. To start, the website takes your preferred day plus an arrival window, or a call 8 AM–7 PM on any day of the week reaches the office, which confirms by phone.
Each tab carries a photo from our service work and the first checks we make on that job. Choose a tab, or let them change by themselves.

No. 1
Olympia winters stay wet and just above freezing for weeks, so defrost does a lot of work. We read the coil sensor, the defrost board and the charge before anything else.
Go to the service page
No. 2
Cooling was an afterthought in many South Sound homes until the 2021 heat dome. When a newer system lags on a hot day, airflow, the capacitor and the charge come first.
Go to the service page
No. 3
Gas or electric, a furnace that quits on a cold morning is traced step by step: thermostat call, inducer, pressure switch, igniter, flame sensor, limit.
Go to the service page
No. 4
A new system starts with a load calculation and a dry, level pad. Prairie gravel drains fast; in low clay corners we set the unit higher.
Go to the service page
No. 5
Ductless heads suit older Olympia houses with no space for ducts. The line set runs outside, so its insulation and the condensate drain get a close look.
Go to the service page
No. 6
Spring and fall visits clear needles and moss from the coil, open the drain holes in the base and test the defrost cycle before the long gray season.
Go to the service page
No. 7
Warm shelves usually come from frost on the coil, a fan that has stopped or a failed defrost part. Sealed-system repairs happen at home, by technicians holding EPA 608 Universal credentials.
Go to the service page
No. 8
Rural wells around Yelm and Rochester carry sediment that clogs inlet screens. A slow fill or a musty front-loader boot is where most washer visits start.
Go to the service page
No. 9
Damp air and long vent runs make lint pile up fast in South Sound laundry rooms. The vent is tested together with the element or burner and the thermal fuse.
Go to the service page
No. 10
Cloudy glasses and a tub that will not drain point to the filter, the drain pump or a hose without its loop under the counter. Each gets checked in order.
Go to the service page
No. 11
Bake and broil elements, igniters and the oven sensor are metered before any part is ordered, on gas, electric and induction models alike.
Go to the service page
No. 12
When the ice stops after a power outage, the fill tube has often frozen. We check the water valve, the filter and the tube before blaming the ice maker.
Go to the service pageBecause a list would be wrong for most visits. One symptom, such as a furnace that lights and then shuts off, can trace to a dirty flame sensor, a weak inducer or a cracked pressure switch hose, and each fix is different. So we share the diagnostic fee before the visit, test the equipment, and then write the repair price for your exact system or appliance.
Just the diagnostic fee. Our technician runs the tests, walks you through the failure and puts a repair price in writing. Choose not to proceed, for whatever reason, and the visit closes there with nothing tacked on. The written price stays in your hands, so you can return to it later, budget for it, or simply set it aside.
No. When you accept the repair, the diagnostic fee lives within the repair total, so the written price covers both the visit and the fix. The fee only stands alone if the repair is declined. Either way, the office shares that amount before anything is scheduled, never as a surprise at the end of the visit.
You see the cost of the ordered part on the written estimate first, and the order goes in only after you approve it. The technician matches the part to the model and serial number so the correct one arrives. When it comes in, the office calls to schedule the return visit, and your invoice will carry the warranty terms.
The terms are written on your invoice and cover the specific parts replaced or equipment installed. If the same fault reappears, phone the office, have the invoice close by, and mention the earlier visit. The technician checks the original work, and anything those terms cover is handled as the invoice describes. Terms for a single part and a whole new system can differ, so read them there.
Ready when you are
Online, select your day and the arrival window you like. By phone, 8 AM–7 PM daily, ask the office for the diagnostic fee before you commit to anything.
Online booking
Tell us what is acting up and when suits you. A coordinator phones to confirm the slot, and your technician calls again when heading your way.
These registrations are open to anyone. Look the numbers up on L&I Verify, and see our licenses page for what each one covers.
Read what each license allows